![]() ![]() On the other hand, with tunnel/proxy solutions, the data is always relayed via a central server. The two VPN solutions described below are “peer to peer” systems: a central server sets up the connection between clients, who then communicate directly (in the minority of cases where this is not possible, the system falls back to relaying data via the server). A number of these solutions are described below, with setup instructions. If you can’t use port forwarding for any reason, the solution is to set up a VPN or Tunnel (sometimes called a proxy) via a third-party service in order to access your system. Institutions with very strict network policies may have a blanket ban on allowing any kind of incoming connections from the Internet.ISP routers sometimes prevent users from setting port forwarding rules.your ISP router plus your own router), port forwarding configuration is difficult – the usual solution is to switch one of these routers to bridge/passthrough mode, but this isn’t always possible. If you have two routers between the Mac and the Internet (e.g.Port forwarding only works when your ISP gives you a true public IP address, which is not always the case, especially with cellular or satellite internet connections (e.g.However, some users may want to consider other methods for the following reasons: ![]() This method is great for most users, as it usually allows high-performance remote access with minimal configuration. This method allows direct incoming connections to SecuritySpy from the Internet, and is enabled by some configuration in your router (which, for most routers, SecuritySpy can do automatically). The usual way to set up remote access to our macOS CCTV software SecuritySpy running on your Mac is via port forwarding (see Installation Manual – Remote Access).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |